Andres Robotics and Science
  • Science (s2)
  • Robotics (s2)
  • Pius Wrestling
    • Dummy Set-ups
    • Intensive Camp 2020
    • Doubles
    • High C
    • Sweep
    • Pius X Varsity Wrestling
    • JV Awards
Slant Mazes 5-8 (free code)

CNC Plotter

A. find "Motor Control"
Picture
Picture

B. Get a maze & marker from the front.

c. Read the challenge below

Picture
1. CNC Plotter maze
Program for Maze Challenge
1.
Wheel--port A
Gear rack--port D
Picture
2.
move gear rack left so that it is over "Start" on maze 1
Picture
3.
Click start button to reset motor sensor to zero
Change each motor setting to rotations
Picture
4.
A. Drive up and over

B. enter X & Y values into motor A and D

C. reset motor sensors to zero & repeat A & B above


Picture
Picture

Move a Tire Challenge Example

Picture

How to Install your EV3 onto your Chassis

EV3-->Chassis Part 1
EV3--> Chassis Part 2
Picture
Picture
Picture
Picture

You will need install your EV3 into a chassis to get to the castle.  You will use Robot Educator to complete the "Basics and Beyond Basics"  located in Mindstorm Lobby)   click-------------------------.>
Robot Educator

1. Go to the Lobby   2. Select Robot Educator  3.  Select Basics    4. Select "Straight Move"

Picture
Picture

How to switch out the battery

Video: replacing battery
Picture

1. Tickle Button
2. Beating Heart
3. Jaws
4. Eye Reaction
5. Happy Birthday
6. Stop Watch
7. My Block

Maze 5-8


Wind Tank building Instructions
Wind Tank Modification
555 Chip